Xerox 8825 - REP 8.2 Media Exit Switch

01/02
4-23
8825/8830 Printer
REP 8.2
Repairs and Adjustments
REP 8.2 Media Exit Switch
Parts List on PL 8.4
WARNING
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Latch the Xerographic Module at the Service Position (REP 9.2).
2. Remove the Media Transport Assembly (REP 8.1).
3. Remove the Fabric Guide (REP 8.9).
4. (Figure 1): Remove the Front Pivot Assembly.
5. Turn the Front Pivot Assembly over and remove the Media Exit Switch.
a. Disconnect the Switch Assembly Connector Q3.
b. Remove the screw and the Stacker Support.
c. Remove the Media Exit Switch from the bracket.
Figure 1 Removing the Front Pivot Assembly
4
Remove the Front Pivot
Assembly
3
Remove the screws (both
sides)
2
Loosen the screws (both
sides)
1
Disconnect the connector
from the clutch
Front Pivot Assembly