Yamaha CS1D - Pairing Settings

Chapter 4. Basic operation for input channels
43
Pairing settings
Monaural input channels can be paired so that their principal parameters are linked.
[Procedure]
1. For adjacent odd-numbered → even-numbered
input channels, hold down one of the [SEL]
switches and press the other [SEL] switch.
The direction in which the channel parameters are
copied will depend on the order in which the [SEL]
switches are pressed. When you create a pair, the
parameters of the channel you pressed first will be
copied to the channel that you pressed next, and will
subsequently be linked.
For example if you pair CH 1 and CH 2, holding
down the CH 1 [SEL] switch and then the CH 2
[SEL] switch will cause the state of CH 1 to be copied
to CH 2. For details on the parameters that are cop-
ied/linked when paired, refer to “CS1D Reference
Manual (Appendices)” (→p.45). If you wish to reset
the parameters, do so from the screen.
2. To cancel pairing, hold down the [SEL] switch of
one of the paired channels and press the [SEL]
switch for the other channel.
Hint
It is also possible to set/cancel pairing within the dis-
play.