CS1D Operating Manual (Basic Operation)
116
Cue/Solo groups
The cue/solo signals of the PM1D system can be categorized into the following three groups.
• INPUT CUE group
These are the cue/solo signals of the input channels.
They are enabled when the [CUE] switch of an input
channel or ST IN channel is pressed.
• Input channel [CUE] switch
• ST IN channel [CUE] switch
• DCA CUE group
These are the cue/solo signals of the DCA groups.
They are enabled when a [CUE] switch in the DCA
GROUP block is pressed.
• DCA GROUP block [CUE] switch
Hint
For details on DCA groups, refer to “Chapter 7. DCA
groups/Mute groups.”
• OUTPUT CUE group
These are the cue/solo signals of output channels.
They are enabled when the [CUE] switch of a MIX
channel, MATRIX channel, or STEREO A/B channel
is pressed.
• MIX/MATRIX channel [CUE] switch
• STEREO A/B channel [CUE] switch
It is not possible for the [CUE] switches of these
three groups to be on simultaneously. The group
for the last-pressed [CUE] switch will be given pri-
ority, and the cue/solo signals of that group will be
enabled.
For details on cue operation, refer to “CS1D Refer-
ence Manual (Hardware)” (→p.81).
CUE
CUE
10 11 12
CUE CUE
ST OUTPUT
A
ST OUTPUT
B
To Next Page
Loading...
