Effects Parameters
33
• AMP SIMULATE [Type: MIX]
• DYNA. FILTER [Type: STEREO]
• DYNA. FLANGE [Type: STEREO]
Parameter Range Description
AMP TYPE
STK-M1, STK-M2, THRASH,
MIDBST, CMB-PG, CMB-VR,
CMB-DX, CMB-TW, MINI
Guitar amp simulation type
DST TYPE
DST1, DST2, OVD1, OVD2,
CRUNCH
Distortion type (DST= distortion, OVD= overdrive)
NOISE GATE 0 - 20 Noise reduction
DRIVE 0 - 100 Distortion drive
MASTER 0 - 100 Master volume
CAB 0 - 100 [%] Speaker cabinet simulation depth
BASS 0 - 100 Bass tone control
MIDDLE 0 - 100 Middle tone control
TREBLE 0 - 100 High tone control
EQ F 100 - 8.0k [Hz] Parametric equalizer frequency
EQ G –12.0 - +12.0 [dB] Parametric equalizer gain
EQ Q 10.0 - 0.10 Parametric equalizer bandwidth
BALANCE WAT 0 - 100 [%] Wet/dry balance
Parameter Range Description
SENSE 0 - 100 Sensitivity
FILTER TYPE LPF, HPF, BPF Filter type
OFFSET 0 - 100 Filter frequency offset
RESONANCE 0 - 20 Filter resonance
LEVEL 0 - 100 Output level
DIRECTION UP, DOWN Upward or downward frequency change
DECAY
5.0ms - 42.3s(@fs=48kHz),
6.0ms - 46.0s(@fs=44.1kHz)
Filter frequency change decay speed
BALANCE WAT 0 - 100 [%] Wet/dry balance
Parameter Range Description
SENSE 0 - 100 Sensitivity
FB.LEVEL –99 - +99 [%]
Feedback gain (plus values for normal-phase feedback,
minus values for reverse-phase feedback)
HI.RATIO 0.1 - 1.0 High-frequency feedback ratio
OFFSET 0 - 100 Delay time offset
DIRECTION UP, DOWN Upward or downward frequency change
DECAY
5.0ms - 42.3s(@fs=48kHz),
6.0ms - 46.0s(@fs=44.1kHz)
Decay speed
LOW SHEL. F Thru, 21 - 8.0k [Hz] Low-range shelving filter frequency
LOW SHEL. G –12.0 - +12.0 [dB] Low-range shelving filter gain
PEQ F 100 - 8.0k [Hz] Parametric EQ cutoff frequency
PEQ G –12.0 - +12.0 [dB] Parametric EQ gain
PEQ Q 10.0 - 0.10 Parametric EQ Q
HIGH SHEL. F 50 - 16.0k, Thru [Hz] High-range shelving filter frequency
HIGH SHEL. G –12.0 - +12.0 [dB] High-range shelving filter gain
BALANCE WAT 0 - 100 [%] Wet/dry balance