Yamaha CS1D - ST in Block; Channel Assignments for the ST in Block

ST IN block
13
Channel assignments for the ST IN block
The ST IN block contains four modules, two above and two below. In the default state of the PM1D system the lower two
modules are assigned to control ST IN channels 1/2, and the upper two modules are assigned to control ST IN channels
3/4. However, these assignments can be changed as follows in the SELECTED INPUT CHANNEL block MODULE FLIP
section, and the MASTER block GLOBAL LAYER section. {The GLOBAL LAYER section is not available for 48 channel
model.}
Using the MODULE [FLIP] switch to change channel
assignments
Using the GLOBAL LAYER switches to change channel
assignments (96 channel model only)
FLIP
34
12
12
34
FLIP
ST IN block
ST IN block
GLOBAL LAYER
GLOBAL LAYER
34
12
78
56
ST IN block
ST IN block