Yamaha CS1D - Chapter 10. Monitor; Basic Operation of the MONITOR A;MONITOR B Section; About MONITOR A;MONITOR B

110
Chapter 10. Monitor
This chapter explains monitoring functions of the PM1D system such as the MONITOR A/B outputs and the cue/solo
functions.
Basic operation of the MONITOR A/MONITOR B section
About MONITOR A/MONITOR B
The PM1D system provides two monitor outputs, MONITOR A and MONITOR B. For each, the monitoring source can
be selected and the output level set independently. To control MONITOR A/MONITOR B from the CS1D console, you
will use the following sections of the MASTER block.
• MONITOR A section
This section controls the monitor signal that is out-
put from MONITOR OUT jacks A located on the
rear panel of the CS1D or from the MONITOR A
headphone jacks located on the top panel and front
panel of the CS1D. You can select the monitor
source, set the output level, switch between stereo/
mono, and set the delay function.
• MONITOR B section
This section controls the monitor signal that is out-
put from MONITOR OUT jacks B located on the
rear panel of the CS1D or from the MONITOR B
headphone jacks located on the top panel and front
panel of the CS1D. You can select the monitor source
and set the output level.
Hint
MONITOR A/MONITOR B operations can also be
performed within the display (MON/CUE function
MONITOR A screen, MONITOR B screen). By using
these screens, you can make more detailed settings
than can be made in the MONITOR A/MONITOR B
sections.
Please note that the available functions differ
between MONITOR A and MONITOR B. The fol-
lowing table shows the monitor sources that can be
selected for each monitor output, and the functions
that are available.
• Differences between the MONITOR A and MONI-
TOR B functions
*The cue/solo signal can be output indirectly by
selecting MONITOR A as the monitor source.
MONITOR A MONITOR B
Output jacks
MONITOR OUT
jacks A
MONITOR OUT
jacks B
Headphone jack A Headphone jack B
Selectable
monitor
sources
2TR IN 1 2TR IN 1
2TR IN 2 2TR IN 2
ST A ST A
ST B ST B
DEFINE MONITOR A
DEFINE
Delay function ● ✕
Gate function ● ✕
DIRECT IN ● ●
COMM IN
●
✕
DIMMER
●
✕
Cue/solo
signal output
●
✕ (*)