Yamaha CS1D - Checking the Operation of Input Units; Preparations for Checking

30
Checking the operation of input units
This section explains how to check the operation of an input unit connected to the DSP1D-EX {DSP1D} engine.
The general procedure is as follows.
Connect an input source to the input unit
mm
mm
Connect a monitor system (or headphones) to the MONITOR OUT A jacks of the console (or to the MONITOR A
headphone jack)
mm
mm
Tu rn on the power in the order of input unit → DSP1D-EX {DSP1D} engine → CS1D console → monitor system
mm
mm
Patch the input unit to an input channel
mm
mm
Press the [CUE] switch of the input channel
mm
mm
Check whether the signal is output from the MONITOR OUT A jacks (or the MONITOR A headphone jack)
Preparations for checking
Before you begin checking the operation of the input unit, make sure that you have performed the following actions.
• Connect the various components that are part of
the PM1D system ( → p.6–13)
• Use the indicators/LEDs of the input/output units
and the engine to verify that the components are
correctly connected to each other ( → p.14–21)
• Set the operation mode and the word clock master
as appropriate for the configuration of the PM1D
system that you are using ( → p.22–29).