76
Output functions
OUT PATCH (output patch) functions
Assign output units to output channels/insert I/O
OUTPUT PATCH
[Function]
Patch the output jack of a card installed in an output unit or the input of an internal effect to the desired out-
put channel (MIX channel, MATRIX channel, STEREO A/STEREO B channel).
■ Console
In the LCD FUNCTION ACCESS
block, press the OUTPUT [PATCH]
switch (press repeatedly until the
screen shown at the right appears)
■ Display
MENU button → OUTPUT PATCH
button → OUTPUT PATCH tab
[Screen functions]
1 CH (output channel)
This is the number of the output channel (MIX
channel, MATRIX channel, STEREO A/STEREO B
channel) that will be the patch source. The number
corresponding to the grid where the cursor is cur-
rently located will be highlighted.
2 Short name
This displays the short name that has been assigned
to each output channel. You can click this area and
assign a short name/long name.
3 ASSIGN
This shows the number of output jacks that have
been assigned to each output channel.
4 SELECTED PATCH
This shows the number/long name of the output
channel corresponding to the grid where the cursor
is currently located.
5 Grid
In this grid you can patch output jacks (horizontal
lines) to output channels (vertical columns). Cur-
rently-patched grid locations will show a ● symbol.
Move the cursor to the desired grid and press the
[ENTER] switch (or click) to set/defeat a patch.
1
2
3 5
4
To Next Page
Loading...
