Appendices
52
■ High frequency range is muted
• Is emphasis being applied? If the emphasis data does
not match the input signal, the high frequency range
will be muted. (“CS1D Reference Manual (Soft-
ware)” →p.133)
• Is EQ applied? (“CS1D Operation Manual (Basic
Operation)” →p.57, 83)
■ The [ON] switches and [SEL] switches select
the wrong channel
• Make sure that the correct mixing layer is selected.
(“CS1D Reference Manual (Hardware)” →p.5, 13,
41, 47)
■ An input signal is being received, but there
is no monitor output
• Is “CUE INTERRUPTION” turned on? If CUE is
ON, the CUE signal will be output from MONITOR
OUT. (“CS1D Reference Manual (Software)” →p.71)
■ A channel continues to be heard even in
SOLO mode
• Is that channel set to SOLO SAFE? (“CS1D Reference
Manual (Software)” →p.74)
■ Insufficient headroom, especially when EQ
is boosted
• Use the EQ attenuator to lower the level. (“CS1D
Reference Manual (Hardware)” →p.29)
■ Sound recorded via ST OUT DIGITAL or a MY
card with digital output appears fragmented
• Make sure that the dither setting matches the word
length of the recording device. (“CS1D Reference
Manual (Software)” →p.56)
■ Signal phase is incorrect for a stereo pair
• You must set both input channels of a stereo pair to
the same phase setting. Phase settings are not linked
when you specify stereo pairing. (“CS1D Reference
Manual (Hardware)” →p.21)
■ Signal appears to be delayed
• Make sure that the channel delay function is set cor-
rectly. (“CS1D Reference Manual (Hardware)”
→p.22)
■ Some channels are not updated when a
scene memory is recalled
• Are those channels set to Recall Safe? (“CS1D Opera-
tion Manual (Basic Operation)” →p.106)
■ I selected CUE in the EFFECT screen, but it
is defeated without my action
• This will be defeated automatically when you switch
to a different display screen. (“CS1D Reference Man-
ual (Software)” →p.10)
■ Cannot make boost settings in the GEQ
• Is the LIMIT set to –24 dB? (“CS1D Operation Man-
ual (Basic Operation)” →p.136)
■ When a scene is recalled, some time is
required before faders stop moving
• Has the fade time been set? (“CS1D Reference Man-
ual (Software)” →p.25)
■ Unconnected units or uninstalled cards are
displayed
• Have virtual unit or virtual card settings been made?
(“CS1D Reference Manual (Software)” →p.47, 50)
■ CS1D panel LEDs are dim
• Adjust the LED BRIGHTNESS setting in the PREF-
ERENCE screen of the UTILITY function. (“CS1D
Reference Manual (Software)” →p.36)
■ The VERSION CHECK popup window
appeared
• The software/firmware of the component that failed
the test does not match the version of the PM1D sys-
tem. The software/firmware of that component must
be updated.
For details on how to perform the update, refer to the
documentation on the included PM1D system soft-
ware disc.
To Next Page
