Parameter List
10
10.10 H: Terminal Functions
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 565
No.
(Hex.)
Name Description
Default
(Range)
Ref.
H5-06
(042A)
Drive Transmit
Wait Time
Sets the time to wait to send a response message after the drive
receives a command message from the master.
Note:
Restart the drive after you change the parameter setting.
5 ms
(0 - 65 ms)
928
H5-09
(0435)
CE Detection Time
Sets the detection time for CE [Modbus Communication Error]
issues when communication stops.
2.0 s
(0.0 - 10.0 s)
929
H5-10
(0436)
Modbus Register
0025H Unit Sel
Sets the unit of measure used for the MEMOBUS/Modbus
communications monitor register 0025H (output voltage reference
monitor).
0 : 0.1 V units
1 : 1 V units
0
(0, 1)
929
H5-11
(043C)
Comm ENTER
Command Mode
Sets the function to make the Enter command necessary to change
parameters through MEMOBUS/Modbus communications.
0 : ENTER Command Required
1 : ENTER Command Not Required
0
(0, 1)
929
H5-12
(043D)
Run Command
Method Selection
Sets the input method for the Run command when b1-02 = 2 [Run
Command Selection 1 = Memobus/Modbus Communications] or b1-
16 = 2 [Run Command Selection 2 = Memobus/Modbus
Communications].
0 : FWD/Stop, REV/Stop
1 : Run/Stop, FWD/REV
0
(0, 1)
929
H5-17
(11A1)
Expert
ENTER command
response @CPU
BUSY
Sets operation when the EEPROM write command is sent without
EEPROM write available. Usually it is not necessary to change this
setting.
0 : Ignore Command(No ROM/RAM Write)
1 : Write to RAM Only
0
(0, 1)
930
H5-18
(11A2)
Motor Speed Filter
over Comms
Sets the filter time constant used when monitoring motor speed
during MEMOBUS/Modbus communications or with a
communication option.
0 ms
(0 - 100 ms)
930
H5-20
(0B57)
Communication
Parameters Reload
Sets the function to immediately enable updated MEMOBUS/
Modbus communications parameters.
0 : Reload at Next Power Cycle
1 : Reload Now
0
(0, 1)
930
H5-25
(1589)
RUN
Function 5A
Register 1
Selection
Returns the contents of the specified MEMOBUS/Modbus
communications register when responding to the master device.
0044H (U1-05)
(0000H - FFFFH)
930
H5-26
(158A)
RUN
Function 5A
Register 2
Selection
Returns the contents of the specified MEMOBUS/Modbus
communications register when responding to the master device.
0045H (U1-06)
(0000H - FFFFH)
930
H5-27
(158B)
RUN
Function 5A
Register 3
Selection
Returns the contents of the specified MEMOBUS/Modbus
communications register when responding to the master device.
0042H (U1-03)
(0000H - FFFFH)
931
H5-28
(158C)
RUN
Function 5A
Register 4
Selection
Returns the contents of the specified MEMOBUS/Modbus
communications register when responding to the master device.
0049H (U1-10)
(0000H - FFFFH)
931
To Next Page
Loading...
