Zebra ZM400 Series

Operations
Control Panel Parameters
100
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
Set Real-Time Clock (RTC) Date
This parameter allows you to set the date following the convention selected
in IDLE DISPLAY.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press MINUS (-) to move to the next digit position.
3. Press
PLUS (+) to change the value of the digit.
4. Press
SELECT to accept any changes and deselect the parameter.
Set RTC Time
This parameter allows you to set the time following the convention selected
in
IDLE DISPLAY.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press the left oval
MINUS (-) to move to the next digit position.
3. Press the right oval
PLUS (+) to change the value of the digit.
4. Press SELECT to accept any changes and deselect the parameter.
Specify Password Level
This parameter allows you to select whether certain factory-selected menu
items or all menu items are password protected.
Default Value: SELECTED ITEMS
Selections: SELECTED ITEMS, ALL ITEMS
1. Press
SELECT to select the parameter.
2. Press
PLUS (+) or MINUS (-) to toggle between the options.
3. Press SELECT to accept any changes and deselect the parameter.
Table 12 • Printer Parameters (Page 23 of 24)
Parameter
Action/Explanation