Zebra ZM400 Series

167
Corrective Maintenance
Print Mechanism
8/9/07 ZM400/ZM600 Maintenance Manual 14207L-001 A
13. Did you remove a cutter assembly?
14.
15.
Reconnect the AC power cord and data cables.
16. Turn on (l) the printer.
Reinstall the Cutter Assembly
1. See Figure 40 on page 161. Reinstall the cutter assembly on the hooks of the platen
housing.
a. Hold the cutter assembly as far to the left as possible, and align the larger part of the
step slot with the hooks on the platen housing.
b. Slide the cutter assembly onto the hooks and then push down and slide the assembly
to the right.
2. Using the cutter mounting screw removed earlier, secure the cutter assembly onto the
platen assembly.
The mounting tab on the cutter fits behind and attaches to the platen assembly.
3. Turn the latch assembly counterclockwise until it snaps in place.
4.
5.
Reconnect the AC power cord and data cables
6. Turn on (l) the printer.
If… Then…
No Continue with step 14.
Yes Go to Reinstall the Cutter Assembly.
Caution • When you are loading media or ribbon, remove all jewelry that could come
into contact with the printhead or other printer parts.
Reinstall the media and ribbon.
Caution • When you are loading media or ribbon, remove all jewelry that could come
into contact with the printhead or other printer parts.
Reinstall the media and ribbon.