Preventive Maintenance
Cleaning Procedures
134
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
Clean the Media Compartment and Sensors
To clean the media compartment and sensors, complete these steps:
1.
2.
Brush or vacuum any accumulated paper lint and dust away from the media and ribbon
paths.
3. Brush or vacuum any paper lint and dust away from the sensors (see Figure 24).
Figure 24 • Cleaning the Sensors
4.
Caution • While performing any tasks near an open printhead, remove all rings,
watches, hanging necklaces, identification badges, or other metallic objects that could
touch the printhead. You are not required to turn off the printer power when working
near an open printhead, but Zebra recommends it as a precaution. If you turn off the
power, you will lose all temporary settings, such as label formats, and you must reload
them before you resume printing.
Open the media door and remove the media and ribbon.
1
Take-label sensor
2
Ribbon sensor
3
Media sensor
1
3
2
Caution • When you are loading media or ribbon, remove all jewelry that could come
into contact with the printhead or other printer parts.
Reinstall the media and ribbon.
To Next Page
Loading...