Corrective Maintenance
Peel Maintenance Assembly
334
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
Peel Maintenance Assembly
Tools Required
Remove the Old Peel Assembly
1. See Figure 196. Remove the two mounting screws and remove the peel assembly.
Figure 196 • Remove Old Peel Assembly
2. Go to Install the New Peel Assembly on page 335.
Tools • You need these tools to complete this procedure:
Metric Hex Key (Allen wrench) Set
Metric Nutdriver Set
Antistatic Wrist Strap and Mat
1
Peel Assembly
2
Mounting Screw (2)
1
2
To Next Page
Loading...