Zebra ZM400 Series

Corrective Maintenance
222
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
Remove the Media Sensor Connections
1.
2.
See Figure 92. Disconnect the upper media sensor cables from J3 and P7 of the main logic
board (MLB).
Figure 92 • Disconnect the Media Sensor Cables
3. Disconnect the lower media sensor cable from P9 of the main logic board (MLB).
4. Remove the wires from the wire wrap.
5. Continue with Remove the Sensor Assemblies.
Caution • Observe proper electrostatic safety precautions when handling
static-sensitive components such as circuit boards and printheads.
Connect yourself to an antistatic device.
1
Main logic board (MLB)
2
Wire wrap
3
Reflective media sensor connector (P7)
4
Lower media sensor connector (P9)
5
Media detector connector (J3)
1
4
5
2
3