6241A/6242 DC Voltage Current Source/Monitor Operation Manual
4.2.6 MENU Key (Parameter Setting)
4-9
Measure SW Switches measurement ON or OFF.
On: Executes measurement.
Off: Does not execute measurement.
Disp Digit Selects the number of measurement display digits.
Spaces are displayed as blank digits (non-used-digits) and do not
affect any measurement data.
5 digits: Displays measurement data with 5½ digits.
4 digits: Displays measurement data with 4½ digits.
3 digits: Displays measurement data with 3½ digits.
Disp Unit Selects the measurement data, comparable upper and lower limit
value, and output format style.
Prefix: Displays measurement data by using a decimal point
and the unit symbol.
Exponent:
Displays measurement data in exponential form.
Mfunc Link Links the source function to the measurement function.
On: Source function is linked to the measurement function
(VSIM/ISVM).
Off: The measurement function is unaffected by the source
function.
MEMORY Sets the measurement data memory.
• While the ST indicator is on, data is being stored in the
memory.
• When the memory becomes full, the ST indicator blinks and
further data cannot be stored.
• Cannot move to the Setting level during free run in the DC or
Pulse Source mode.
Store Mode Selects measurement-data-memory functions.
The content of the memory is cleared when the Store mode is
changed.
Normal: Stores data in the memory in normal mode.
Burst: Stores data in the memory in burst mode. Used for
high-speed measurement.
Off: Turns the memory storage operation OFF.
Mem Recall Reads the data stored in the measurement data memory onto the
display.
By assigning the recall number on the lower line, it displays the
recall data on the upper line.
The recall number can be set in the range of 0 to 7999. If data is
not stored, “No Data” is displayed.
Mem Clear Clears the content of the measurement data memory.
To Next Page
Loading...
General