6241A/6242 DC Voltage Current Source/Monitor Operation Manual
6.7.3 Remote Command List
6-28
Sweep
Two Slope Linear
Sweep
SM fd: first value
0.01 mV/
0.001 μA
[±fd, ±md,
±ld, st1, st2]
md: middle value
1 mV/
0.1 μA
ld: last value
2 mV/
0.2 μA
st1:Step 1 value
0.01 mV/
0.001 μA
st2:Step 2 value
0.01 mV/
0.001 μA
If all the settings are omitted, set Sweep type only.
However it is not allowed to omit each value separately.
SM? Response: SM<±fd>, ±<md>,±<ld>,<st1>,<st2>
*1
fd,md,ld,,st1,st2: <d.ddddE±d>
Sweep type SX? Responds to the sweep type current source function.
Response: Linear sweep:
Same as the SN? response
Fixed level sweep:
Same as the SF? response
Random sweep:
Same as the SC? response
Two Slope Linear Sweep:
Same as the SM? response
*1: The response decimal point is different depending on the set value.
For the source value, limit value, and time parameter set up range, refer to the performance specifications.
Item Command Description
Default Operation
Power
ON
Default
setting
During DC/
pulse
operation and
suspension
During
sweep
operation and
suspension
To Next Page
Loading...