6241A/6242 DC Voltage Current Source/Monitor Operation Manual
6.7.3 Remote Command List
6-37
GPIB SRQ S0 ON
*5
S1 OFF
S? Response: S0 or S1
Status *STB? Query of the Status Byte Register (STB)
Response: ddd
*SRE
Sets the Service Request Enable Register (0 to
255).
0*6
*SRE? Response: ddd
*ESR? Query of the Standard Event Status Register (ESR)
Response: ddd
*ESE
Sets Standard Event Status Enable Register (0
to 255).
0*6
*ESE? Response: ddd
DSR? Query of the Device Event Status Register (DSR)
Response: ddddd
DSE
Sets the Device Event Status Enable Register (0 to
65535).
0*6
DSE? Response: ddddd
ERR? Query of the Error Register description (ERR)
Response: ddddd
*CLS Clears the status.
Operation com-
plete
*OPC After completing all the operation, set LSB of the Stan-
dard Event Status Register
*OPC? Response: 1 (after all operation completed)
*WAI Waits until all the operation is complete (GPIB only).
*5: It is not initialized by RINI command.
*6: It is not initialized by RINI or *RST command.
Item Command Description
Default Operation
Power
ON
Default
setting
During DC/
pulse
operation and
suspension
During
sweep
operation and
suspension
To Next Page
Loading...
General