125
Compatible SCPI Commands
Supported SCPI Commands
MMEMory:LOAD:AUTO 1,<file_name>
Specifies a settings file, the contents of which will automatically be loaded (and set as the analyzer state)
when the analyzer is switched on.
MMEMory:MDIRectory <directory_name>
Creates the new directory specified by <directory_name>.
MMEMory:MOVE <file_source>,<file_destination>
If <file_destination> contains no path information, then <file_source> is renamed to <file_destination>.
If <file_destination> contains path information, <file_source> is moved to the specified path, and
renamed if <file_destination> also includes a file name.
MMEMory:MSIS <device>
This command is accepted, but takes no action and reports no error.
MMEMory:NAME <file_name>
The command specifies the path and name of the destination file, for use when a print-to-file operation is
initiated using the command HCOPy:IMMediate.
The specified destination file type must be PNG.
Remote Command :MMEMory:LOAD:AUTO 1,<string>
Example :MMEM:LOAD:AUTO 1,’myState.state’
Remote Command Notes FSE, FSP, FSU
Remote Command :MMEMory:MDIRectory <string >
Example :MMEM:MDIR ‘C:\T1’
Remote Command Notes FSE, FSP, FSU
Remote Command :MMEMory:MOVE <string>,<string>
Example :MMEM:MOVE ‘C:\test.txt’ ‘D:’
Remote Command Notes FSE, FSP, FSU
Remote Command :MMEMory:MSIS <string >
:MMEMory:MSIS?
Example :MMEM:MSIS ‘A:’
Remote Command Notes FSE, FSP, FSU
To Next Page
Loading...
