Agilent Technologies EXA N9010A - Trigger<1|2>[:Sequence]:Slope

164
Compatible SCPI Commands
Supported SCPI Commands
TRIGger<1|2>[:SEQuence]:SLOPe
Sets the trigger signal slope to positive or negative.
The trigger slope setting applies to all trigger sources.
Remote Command :TRIGger[1][:SEQuence]:SLOPe POSitive|NEGative
:TRIGger[1][:SEQuence]:SLOPe?
Example TRIG:SLOP NEG
Remote Command Notes FSE, FSP, FSU
Preset POSitive
State Saved Saved in instrument state.
Range POSitive|NEGative
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html