20
Getting Started
SCPI Language Compatibility Application General Rules and Limitations
Supported Commands and Queries
Only a subset of the FSE/FSP/FSU series commands is supported in the N9062A/W9062A application.
The list of supported commands was determined by feedback from our customers combined with
technical considerations and constraints.
The supported FSE/FSP/FSU commands are summarized with short notes in Table 3-1 on page 38. In
some case, a command is accepted without error, but no action taken, for example, a display line.
Unsupported Commands and Queries
If a command or query is valid for FSE/FSP/FSU products but not supported by the N9062A/W9062A
application, the X-Series analyzer may handle it in the following way:
• Generate an error message. This kind of SCPI commands is not covered in this manual.
NOTE If your use case is not fully supported, contact your local Agilent Technologies
Sales and Service Office, or if in the United States, call 1-800-829-4444.
To Next Page
Loading...
