38
Compatible SCPI Commands
SCPI Summary Table
SCPI Summary Table
This table is a brief summary of the FSE/FSP/FSU SCPI commands covered by the N9062A & W9062A
SCPI Language Compatibility application in the X-Series analyzers, with short notes on operation. For
more details, see âSupported SCPI Commandsâ on page 57.
Table 3-1 SCPI Commands Summary Table
SCPI Command Corresponding
Model
Support Notes
Abort FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>[:STATe]
ON | OFF
FSE/FSP/FSU Yes All DELTamarker
functions are not supported
in CCDF and APD
measurements.
CALCulate<1|2>:DELTamarker<1...4>:MODE
ABSolute|RELative
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:AOFF FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:TRACe 1
to 3
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:X 0 to
MAX (frequency | sweep time)
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:X:RELati
ve?
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:Y? FSE/FSP/FSU Yes The only unit supported is
dB.
CALCulate<1|2>:DELTamarker<1...4>:MAXimu
m[:PEAK]
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:MAXimu
m:LEFT
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:MAXimu
m:NEXT
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:MAXimu
m:RIGHt
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:MINimu
m[:PEAK]
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:MINimu
m:LEFT
FSE/FSP/FSU Yes
CALCulate<1|2>:DELTamarker<1...4>:MINimu
m:NEXT
FSE/FSP/FSU Yes
To Next Page
Loading...
Need help?
General
