Agilent Technologies EXA N9010A - [Sense<1|2>:]Sweep:time:auto on | off; [Sense<1|2>:]Sweep:count 0 to 32767; [Sense<1|2>:]Sweep:egate on | off

149
Compatible SCPI Commands
Supported SCPI Commands
[SENSe<1|2>:]SWEep:TIME:AUTO ON | OFF
Automatically couples sweep time to the frequency span and bandwidth settings.
[SENSe<1|2>:]SWEep:COUNt 0 to 32767
Specifies the number of single sweeps that are used to calculate the average or maximum value.
SCPILC mode supports the maximum value of 10000, not 32767 as in FSx.
[SENSe<1|2>:]SWEep:EGATe ON | OFF
Switches on or off sweep control by an external gate signal.
Remote Command [:SENSe]:SWEep:TIME:AUTO OFF|ON|0|1
[:SENSe]:SWEep:TIME:AUTO?
Example SWE:TIME:AUTO OFF
Remote Command Notes FSE, FSP, FSU
Preset ON
State Saved Saved in instrument state.
Remote Command [:SENSe]:SWEep:COUNt <int>
[:SENSe]:SWEep:COUNt?
Example SENS:SWE:COUN 1000
SENS:SWE:COUN?
Remote Command Notes FSE, FSP, FSU
Preset 0
State Saved Saved in instrument state.
Min 0
Max 10000
Remote Command [:SENSe]:SWEep:EGATe ON|OFF|1|0
[:SENSe]:SWEep:EGATe?
Example SWE:EGAT ON
SWE:EGAT?
Remote Command Notes FSE, FSP, FSU
Preset OFF
State Saved Saved in instrument state.
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html