Agilent Technologies EXA N9010A - Hcopy:device:language<1|2> GDI | WMF | EWMF | BMP; Hcopy[:Immediate<1|2>]; Hcopy:item:all; Hcopy:item:window<1|2>:Table:state on | off

11 6
Compatible SCPI Commands
Supported SCPI Commands
HCOPy:DEVice:LANGuage<1|2> GDI | WMF | EWMF | BMP
This command is accepted, but takes no action and reports no error.
HCOPy[:IMMediate<1|2>]
Initiates hard copy output. The numeric suffix specifies which printer configuration should be used for
the output. If there is no suffix, configuration 1 is selected.
HCOPy:ITEM:ALL
This command is accepted, but takes no action and reports no error.
HCOPy:ITEM:WINDow<1|2>:TABle:STATe ON | OFF
This command is accepted, but takes no action and reports no error.
Remote Command Notes FSE, FSP, FSU
Preset OFF
State Saved Saved in instrument state.
Remote Command :HCOPy:DEVice:LANGuage[1]|2 GDI|WMF|EWMF|BMP
:HCOPy:DEVice:LANGuage?
Example HCOP:DEV:LANG GDI
HCOP:DEV:LANG?
Remote Command Notes FSE, FSP, FSU
State Saved Saved in instrument state.
Range GDI | WMF | EWMF | BMP
Remote Command :HCOPy[:IMMediate]
Example HCOP:IMM
Remote Command Notes FSE, FSP, FSU
Remote Command :HCOPy:ITEM:ALL
Example HCOP:ITEM:ALL
Remote Command Notes FSE, FSP, FSU
Remote Command :HCOPy:ITEM:WINDow[1]|2:TABLe:STATe ON|OFF|1|0
:HCOPy:ITEM:WINDow[1]|2:TABLe:STATe?
Example HCOP:ITEM:WIND:TABL:STAT OFF
HCOP:ITEM:WIND:TABL:STAT?
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html