71
Compatible SCPI Commands
Supported SCPI Commands
CALCulate<1|2>:LIMit<1...6>:DELete
Deletes the specified limit line.
CALCulate:LIMit:ESPectrum Subsystem
The CALCulate:LIMit:SPECtrum subsystem defines the limit check for spectrum emission
measurements.
The following SCPI commands of this subsystem are accepted by the analyzer, but result in no action,
and report no error.
CALCulate<1|2>:LIMit<1...6>:ESPectrum:MODE AUTO | MANual | USER
This command is accepted, but takes no action and reports no error.
CALCulate<1|2>:LIMit<1...6>:ESPectrum:VALue <numeric_value>
Sets manual limit line selection. The limit line is selected by specifying the expected dBm power.
This command is accepted, but takes no action and reports no error.
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:DELete
Example CALC:LIM:DEL
Remote Command Notes FSE, FSP, FSU
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:ESPectrum:MODE
AUTO|MANual|USER
:CALCulate[1]:LIMit[1]|2|3|4|5|6:ESPectrum:MODE?
Example CALC:LIM:ESP:MODE AUTO
CALC:LIM:ESP:MODE
Remote Command Notes FSP
Preset AUTO
State Saved
Saved in instrument state.
Range AUTO | MANual | USER
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:ESPectrum:VALue
<integer>
:CALCulate[1]:LIMit[1]|2|3|4|5|6:ESPectrum:VALue?
Example CALC:LIM:ESP:VAL 39
CALC:LIM:ESP:VAL?
Remote Command Notes FSP
Preset 0
To Next Page
Loading...
Need help?
General
