79
Compatible SCPI Commands
Supported SCPI Commands
CALCulate<1|2>:LIMit<1...6>:CONTrol:SHIFt <numeric_value>
The command shifts the specified limit line in the X-direction, by the specified value.
The query returns the current value of this setting for the specified limit line.
CALCulate<1|2>:LIMit<1...6>:CONTrol:SPACing LINear | LOGarithmic
The command switches between linear or logarithmic interpolation for calculation of limit lines from
frequency points.
The query returns the current state of this setting.
CALCulate:LIMit:LOWer Subsystem
The CALCulate:LIMit:LOWer subsystem controls the lower limit line.
NOTE All limit functions are not supported in the CCDF and APD measurements.
CALCulate<1|2>:LIMit<1...6>:LOWer[:DATA] <numeric_value>,<numeric_value>..
The command defines a set of values for the specified lower limit line.
Range RELative | ABSolute
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:CONTrol:SHIFt <real>
:CALCulate[1]:LIMit[1]|2|3|4|5|6:CONTrol:SHIFt?
Preset 0
SCPI Command Notes SCPI
Command Notes
FSE, FSP, FSU
SCPI Example[DEF]SCPI
Example
CALC:LIM:CONT:SHIF 1
CALC:LIM:CONT:SHIF?
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:CONTrol:SPACing
LINear|LOGarithmic
:CALCulate[1]:LIMit[1]|2|3|4|5|6:CONTrol:SPACing?
Example CALC:LIM:CONT:SPAC LOG
CALC:LIM:CONT:SPAC
Remote Command Notes FSE, FSP, FSU
Preset LIN
State Saved
Saved in instrument state.
Range LINear | LOGarithmic
To Next Page
Loading...
Need help?
General
