96
Compatible SCPI Commands
Supported SCPI Commands
CALCulate<1|2>:MARKer<1...4>:FUNCtion:NOISe:RESult?
Queries the noise measurement result.
To obtain a valid result, a complete sweep must be performed after switching on the function, but before
querying the measured value. This is possible only in Single sweep mode.
CALCulate<1|2>:MARKer<1...4>:FUNCtion:REFerence?
Sets the reference level to the power measured by the specified marker.
If marker 2, 3 or 4 is selected, and used as delta marker, it is switched to marker mode.
This command is an event, and therefore has neither *RST value nor query.
The value of the numeric suffix <1 to 4> is ignored.
CALCulate:MARKer:FUNCtion:POWer Subsystem
The CALCulate:MARKer:FUNCtion:POWER subsystem includes commands for control of power
measurement.
CALCulate<1|2>:MARKer<1...4>:FUNCtion:POWer:SELect ACPower | CPOWer |
MCACpower | OBANdwidth | OBWidth | CN | CN0
Selects and activates the specified power measurement type.
This mode supports: ACPower, MCACpower, CPOWer, OBANdwidth and OBWidth.
CALCulate<1|2>:MARKer<1...4>:FUNCtion:POWer:RESult? ACPower | CPOWer |
MCACpower | OBANdwidth | OBWidth | CN | CN0
Queries the result for the specified power measurement type.
Remote Command :CALCulate[1]:MARKer[1]|2|3|4:FUNCtion:NOISe:RESult?
Example CALC:MARK:FUNC:NOIS:RES?
Remote Command Notes FSE, FSP, FSU
Remote Command :CALCulate[1]:MARKer[1]|2|3|4:FUNCtion:REFerence
Example CALC:MARK:FUNC:REF
Remote Command Notes FSE, FSP, FSU
Remote Command CALCulate[1]:MARKer[1]|2|3|4:FUNCtion:POWer:SELect
ACPower|CPOWer|MCACpower|OBANdwidth|OBWidth|CN|CN0
Example CALC:MARK:FUNC:POW:SEL OBW
Remote Command Notes FSE, FSP, FSU
To Next Page
Loading...
Need help?
General
