83
Compatible SCPI Commands
Supported SCPI Commands
NOTE All limit functions are not supported in the CCDF and APD measurements.
CALCulate<1|2>:LIMit<1...6>:UPPer[:DATA] <numeric_value>,<numeric_value>..
The command defines a set of values for the specified upper limit line.
This mode does not support any unit for this command.
The query returns the current value set.
CALCulate<1|2>:LIMit<1...6>:UPPer:STATe ON | OFF
The command activates or deactivates the specified upper limit line. Limit check is activated separately,
using CALC:LIM:STAT ON.
The query returns the current state of this setting.
CALCulate<1|2>:LIMit<1...6>:UPPer:OFFSet <numeric_value>
The command defines an offset for the Y-axis of the specified relative upper limit line.
This mode does not support any unit for this command.
The query returns the current value of this setting.
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer[:DATA]
<real>,<real>âĻ
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer[:DATA]?
Example CALC:LIM:UPP:DATA â10,0,0,â10,â5
CALC:LIM:UPP:DATA?
Remote Command Notes FSE, FSP, FSU
State Saved Saved in instrument state.
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:STATe ON|OFF|1|0
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:STATe?
Example CALC:LIM:UPP:STAT OFF
CALC:LIM:UPP:STAT?
Remote Command Notes FSE, FSP, FSU
Preset OFF
State Saved Saved in instrument state.
Remote Command CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:OFFSet <real>
CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:OFFSet?
To Next Page
Loading...
Need help?
General
