152
Compatible SCPI Commands
Supported SCPI Commands
STATus Subsystem
The STATus subsystem provides the status reporting system commands. The status registers are not
influenced by *RST.
STATus:OPERation[:EVENt]?
Queries the contents of the EVENt section in the STATus:OPERation register. After the readout, the
contents of the EVENt section are deleted.
STATus:OPERation:CONDition?
Queries the CONDition section in the STATus:OPERation register. The current hardware status is
reflected in the value returned. The contents of the CONDition section are not deleted after the readout.
STATus:OPERation:ENABle
Specifies the bits of the ENABle section in the STATus:OPERation register.
This mode supports the maximum value of 32767, not 65535 as in FSx.
State Saved Saved in instrument state.
Min 1
Max 8001
Remote Command :STATus:OPERation[:EVENt]?
Example STAT:OPER?
Remote Command Notes FSE, FSP, FSU
Preset 0
Remote Command :STATus:OPERation:CONDition
Example STAT:OPER:COND?
Remote Command Notes FSE, FSP, FSU
Preset 0
Remote Command :STATus:OPERation:ENABle <integer>
:STATus:OPERation:ENABle?
Example STAT:OPER:ENAB 1
Remote Command Notes FSE, FSP, FSU
Preset 0
Min 0
Max 32767
To Next Page
Loading...
