151
Compatible SCPI Commands
Supported SCPI Commands
[SENSe<1|2>:]SWEep:EGATe:LENGth 0 to 100 s
For edge triggering, specifies the time interval during which the instrument sweeps.
[SENSe<1|2>:]SWEep:EGATe:SOURce EXTernal | IFPower | RFPower
Switches between an external gate signal and an IF power signal as the signal source for the gate mode.
[SENSe<1|2>:]SWEep:POINts 125 to 8001
Specifies the number of measurement points for one sweep run.
Max 100s
Remote Command [:SENSe]:SWEep:EGATe:LENGth <time>
[:SENSe]:SWEep:EGATe:LENGthÃ7O
Example SWE:EGAT:LENG 1
SWE:EGAT:LENG?
Remote Command Notes FSE, FSP, FSU
Preset 1.25eâ7
State Saved Saved in instrument state.
Min 0
Max 100s
Remote Command [:SENSe]:SWEep:EGATe:SOURce EXTernal|IFPower|RFPower
[:SENSe]:SWEep:EGATe:SOURce?
Example SENS:SWE:EGAT:SOUR EXT
SENS:SWE:EGAT:SOUR?
Remote Command Notes FSE, FSP, FSU
Preset EXTernal
Range EXTernal | IFPower | RFPower
Remote Command [:SENSe]:SWEep:POINts <integer>
[:SENSe]:SWEep:POINts?
Example SWE:POIN 251
SWE:POIN?
Remote Command Notes FSP, FSU
Preset FSP: 501
FSU: 625
To Next Page
Loading...
Need help?
General
