Agilent Technologies EXA N9010A - Calculate<1|2>:Tline<1|2> 0; Calculate<1|2>:Tline<1|2>:State on | off; Calculate:unit Subsystem; Calculate<1|2>:Unit:power DBM | V | a | W | DB | PCT | UNITLESS |DBPW | WATT | DBUV |DBMV | VOLT | DBUA | Ampere

103
Compatible SCPI Commands
Supported SCPI Commands
This command is accepted, but takes no action and reports no error.
CALCulate<1|2>:TLINe<1|2> 0...1000s
Specifies the position of the time lines.
This command is accepted, but takes no action and reports no error.
CALCulate<1|2>:TLINe<1|2>:STATe ON | OFF
Switches the time line on or off.
This command is accepted, but takes no action and reports no error.
CALCulate:UNIT Subsystem
The CALCulate:Unit subsystem specifies the units for power measurement settings.
CALCulate<1|2>:UNIT:POWer DBM | V | A | W | DB | PCT | UNITLESS |DBPW | WATT | DBUV
|DBMV | VOLT | DBUA | AMPere
The command selects the power units.
Remote Command :CALCulate[1]:FLINe[1]|2:STATe ON|OFF|1|0
:CALCulate[1]:FLINe[1]|2:STATe?
Example CALC:FLIN:STAT ON
Remote Command Notes FSE, FSP, FSU
Preset OFF
State Saved Saved in instrument state.
Remote Command :CALCulate[1]:TLINe[1]|2 <time>
:CALCulate[1]:TLINe[1]|2?
Example CALC:TLIN 10ms
Remote Command Notes FSE, FSP, FSU
State Saved Saved in instrument state.
Remote Command :CALCulate[1]:TLINe[1]|2:STATe ON|OFF|1|0
:CALCulate[1]:TLINe[1]|2:STATe?
Example CALC:TLIN:STAT ON
Remote Command Notes FSE, FSP, FSU
Preset OFF
State Saved Saved in instrument state.
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html