85
Compatible SCPI Commands
Supported SCPI Commands
This mode does not support any unit for this command.
The query returns the current value of this setting.
CALCulate<1|2>:LIMit<1...6>:UPPer:SPACing LINear | LOGarithmic
The command switches between linear or logarithmic interpolation for the upper limit line.
The query returns the current state of this setting.
CALCulate<1|2>:LIMit<1...6>:UPPer:THReshold <numeric_value>
The command specifies an absolute threshold value for limit lines with relative Y-axis scaling. The
absolute threshold value is used for the limit check when it exceeds the relative limit value.
This mode supports only dBm units.
The query returns the current value of this setting.
Remote Command CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:SHIFt <real>
CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:SHIFt?
Example CALC:LIM:UPP:SHIF 1
CALC:LIM:UPP:SHIF?
Remote Command Notes FSE, FSP, FSU
Preset 0
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:SPACing
LINear|LOGarithmic
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:SPACing?
Example CALC:LIM:UPP:SPAC LIN
CALC:LIM:UPP:SPAC?
Remote Command Notes FSE, FSP, FSU
Preset LIN
State Saved
Saved in instrument state.
Range LINear | LOGarithmic
Remote Command :CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:THReshold <ampl>
:CALCulate[1]:LIMit[1]|2|3|4|5|6:UPPer:THReshold?
Example CALC:LIM:UPP:THR 1DBM
CALC:LIM:UPP:THR?
Remote Command Notes FSP, FSU
Preset â200dBm
To Next Page
Loading...
Need help?
General
