60
Compatible SCPI Commands
Supported SCPI Commands
ABORt
Aborts any current measurement and resets the trigger system.
CALCulate:DELTamarker Subsystem
The CALCulate:DELTamarker subsystem controls the delta-marker functions.
NOTE All delta marker functions are not supported in the CCDF and APD measurements.
CALCulate<1|2>:DELTamarker<1...4>[:STATe] ON | OFF
When delta marker 1 is selected, this command switches the delta marker on and off.
When any one of delta markers 2 through 4 is selected, that marker becomes the delta marker. If the
marker was not activated, it becomes activated, and is placed at the maximum of the measurement curve.
If the numeric suffix is omitted, delta marker 1 is automatically selected.
The query returns the current state of this setting.
CALCulate<1|2>:DELTamarker<1...4>:MODE ABSolute|RELative
The command switches the frequency input of the delta marker between Absolute and Relative modes.
The query returns the current state of this setting.
Remote Command :ABORt
Example :ABOR
Remote Command Notes FSE, FSP, FSU
Remote Command :CALCulate[1]:DELTamarker[1]|2|3|4[:STATe] ON|OFF|1|0
:CALCulate[1]:DELTamarker[1]|2|3|4[:STATe]?
Example CALC:DELT ON
Remote Command Notes FSE, FSP, FSU
Preset OFF
State Saved Saved in instrument state.
Remote Command :CALCulate[1]:DELTamarker[1]|2|3|4:MODE
ABSolute|RELative
:CALCulate[1]:DELTamarker[1]|2|3|4:MODE?
Example CALC:DELT:MODE ABS
CALC:DELT:MODE REL
CALC:DELT:MODE?
To Next Page
Loading...
Need help?
General
