162
Compatible SCPI Commands
Supported SCPI Commands
TRIGger Subsystem
This subsystem includes commands that control and synchronize the start of a sweep.
An external trigger signal can be supplied via the connector on the analyzer’s rear panel.
TRIGger<1|2>[:SEQuence]:SOURce
Selects the trigger source.
This mode supports only parameter options: IMMediate, EXTernal, VIDeo, RFPower.
It does not support parameter options: IFPower, TV, AF, FM, AM and PM.
TRIGger<1|2>[:SEQuence]:LEVel:IFPower –30 to –10DBM
This command sets the level of the IF power trigger source.
This command is accepted, but takes no action and reports no error.
TRIGger<1|2>[:SEQuence]:LEVel:RFPower
Sets the RF power trigger level.
Preset OFF
State Saved Saved in instrument state.
Remote Command :TRIGger[1][:SEQuence]:SOURce
IMMediate|EXTernal|VIDeo|IFPower|RFPower|TV|AF|FM|AM|PM
:TRIGger[1][:SEQuence]:SOURce?
Example TRIG:SOUR EXT
Remote Command Notes
Remote Command Notes FSE, FSP, FSU
Preset IMMediate
Range IMMediate|EXTernal|VIDeo|IFPower|RFPower|TV|AF|FM|AM|PM
Remote Command :TRIGger[1][:SEQuence]:LEVel:IFPower <ampl>
:TRIGger[1][:SEQuence]:LEVel:IFPower?
Example TRIG:LEV:IFP –20DBM
Remote Command Notes FSP, FSU
Preset –20dBm
State Saved Saved in instrument state.
Min 30dBm
Max –70dBm
To Next Page
Loading...
