Agilent Technologies EXA N9010A - Calculate<1|2>:Deltamarker<1; Numeric_Value

65
Compatible SCPI Commands
Supported SCPI Commands
CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:FIXed:RPOint:MAXimum[:PEAK]
<numeric_value>
Sets the reference point for all delta markers when you are making measurements using a fixed reference
point (enabled by the command CALC:DELT:FUNC:FIX:STAT ON). You can specify a value using the
<numeric_value> parameter, or specify the peak of the selected trace [:PEAK].
For phase-noise measurements (selected via CALCulate:DELTamarker:FUNCtion:PNOise:STATe ON),
the command specifies a new reference point for delta marker 2.
CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:FIXed:RPOint:Y <numeric_value>
Sets or queries a Y-axis reference point for all delta markers when you are making measurements using a
fixed reference point (enabled by CALCulate:DELTamarker:FUNCtion:FIXed:STATe ON).
For phase-noise measurements (selected via CALCulate:DELTamarker:FUNCtion:PNOise:STATe ON),
the command specifies a new reference point level for delta marker 2.
CALCulate<1|2>:DELTamarker<1...4>:FUNCtion:FIXed:RPOint:Y:OFFSet <numeric_value>
Sets or queries the additional offset for all delta markers when you are making measurements using a
fixed reference value (enabled by CALCulate:DELTamarker:FUNCtion:FIXed:STATe ON).
For phase-noise measurements (selected via CALCulate:DELTamarker:FUNCtion:PNOise:STATe ON),
specifies an additional offset that is included in the display of delta marker 2.
Remote Command :CALCulate[1]:DELTamarker[1]|2|3|4:FUNCtion:FIXed:RPOin
t:MAXimum[:PEAK]
Example CALC:DELT:FUNC:FIX:RPO:MAX
Remote Command Notes FSP, FSU
Remote Command :CALCulate[1]:DELTamarker[1]|2|3|4:FUNCtion:FIXed:RPOin
t:Y <amplitude>
:CALCulate[1]:DELTamarker[1]|2|3|4:FUNCtion:FIXed:RPOin
t:Y?
Example CALC:DELT2:FUNC:FIX:RPO:Y –10DBM
CALC:DELT2:FUNC:FIX:RPO:Y?
Remote Command Notes FSE, FSP, FSU
Remote Command :CALCulate[1]:DELTamarker[1]|2|3|4:FUNCtion:FIXed:RPOin
t:Y:OFFSet <rel_ampl>
:CALCulate[1]:DELTamarker[1]|2|3|4:FUNCtion:FIXed:RPOin
t:Y:OFFSet?
Example CALC:DELT2:FUNC:FIX:RPO:Y:OFFS 10DB
CALC:DELT2:FUNC:FIX:RPO:Y:OFFS?
Remote Command Notes FSE, FSP, FSU
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html