145
Compatible SCPI Commands
Supported SCPI Commands
[SENSe<1|2>:]POWer:ACHannel:REFerence:AUTO ONCE
Sets the relative measurementâs reference value to the currently measured channel power.
This command is accepted, but takes no action and reports no error.
[SENSe<1|2>:]POWer:ACHannel:REFerence:TXCHannel:AUTO MINimum | MAXimum |
LHIGhest
Activates the automatic selection of the transmission channel that is used as a reference channel in
relative adjacent-channel power measurements.
[SENSe<1|2>:]POWer:ACHannel:REFerence:TXCHannel:MANual 1 | 2 | 3 | 4
Selects the transmission channel to use as a reference channel in relative adjacent-channel power
measurements.
The command is only available for multicarrier and adjacent-channel power measurements.
Preset ABSolute
State Saved
Saved in instrument state.
Range ABSolute|RELative
Remote Command [:SENSe]:POWer:ACHannel:REFerence:AUTO ONCE
Example POW:ACH:REF:AUTO ONCE
Remote Command Notes FSE, FSP, FSU
State Saved Saved in instrument state.
Remote Command [:SENSe]:POWer:ACHannel:REFerence:TXCHannel:AUTO
MINimum|MAXimum|LHIGhest
[:SENSe]:POWer:ACHannel:REFerence:TXCHannel:AUTO?
Example SENS:POW:ACH:REF:TXCH:AUTO MIN
Remote Command Notes FSP, FSU
State Saved
Saved in instrument state.
Range MINimum | MAXimum | LHIGhest
Remote Command [:SENSe]:POWer:ACHannel:REFerence:TXCHannel:MANual 1 | 2
[:SENSe]:POWer:ACHannel:REFerence:TXCHannel:MANual?
Example POW:ACH:REF:TXCH:MAN 2
POW:ACH:REF:TXCH:MAN?
Remote Command Notes FSP, FSU
To Next Page
Loading...
Need help?
General
