10 (327) BRUKER BIOSPIN User Manual Version 002
Introduction
In the future version of TopSpin there will be a different way of setting pulse pow-
ers. There will be a watt scale which refers to the pulse power in watts. This al-
lows you to set pulse powers in a spectroscopically more relevant scale.
Moreover, different transmitters and different routings will not anymore have an in
-
fluence on the pulse power setting, since it is referenced to an absolute, not rela-
tive scale. This means however, that some setup routines within this manual will
have to be modified to comply with this. The setting will also be possible on a dB
scale, however with an absolute reference. Power level changes will therefore be
calculated properly using calcpowlev. Where pulse power recommendations are
given in this manual, they will still apply if given in watts, they will however not ap
-
ply in the future version of TopSpin if given in dB.
We will try to release a new version of this manual when the new TopSpin version
is available, whereas possible inconsistencies will be removed. There is no incon
-
sistency with TopSpin vs. 2.1.
Disclaimer 1.1
Any hardware units mentioned in this manual should only be used for their intend-
ed purpose as described in their respective manual. Use of units for any purpose
other than that for which they are intended is taken only at the users own risk and
invalidates any and all manufacturer warranties.
Service or maintenance work on the units must be carried out by qualified
personnel.
Only those persons schooled in the operation of the units should operate
the units.
Read the appropriate user manuals before operating any of the units mentioned.
Pay particular attention to any safety related information.
Safety Issues 1.2
Please refer to the corresponding user manuals for any hardware mentioned in
this manual for relevant safety information.
Contact for Additional Technical Assistance 1.3
For further technical assistance please do not hesitate to contact your nearest
BRUKER dealer or contact us directly at:
BRUKER BioSpin GMBH
am Silberstreifen
D-76287 Rheinstetten
Germany
Phone: + 49 721 5161 0
FAX: + 49 721 5171 01
E-mail: service@bruker.de
Internet: www.bruker.de
To Next Page
Loading...
Need help?
General
