Campbell CR800 Series - Programming Resource Library; Advanced Programming Techniques; Capturing Events; FIGURE 39: Crbasic Editor Program Send File Control Window

Section 7. Installation
171
CRBasic Editor Program Send File Control Window (p. 171) before the program is
sent. To keep data, select Run Now, Run On Power-up, and Preserve data if no
table changed, then press Send Program.
Note To retain data, Preserve data if no table changed must be
selected whether or not a Campbell Scientific mass storage device is
connected.
Program Send Options That Reset Memory
1
Datalogger Support
Software
First Click
Next Click
LoggerNet > Connect >
Program Send
PC400 >
Clock/Program > Send Program
PC200W >
Clock/Program > Send Program
RTDAQ >
Clock/Program > Send Program
DevConfig >
Logger Control > Send Program
1
Reset memory and set CRBasic program attributes to Run Always
FIGURE 39: CRBasic Editor Program Send File Control
window
7.7 Programming Resource Library
This library of notes and CRBasic code addresses a narrow selection of CR800
applications.
7.7.1 Advanced Programming Techniques
7.7.1.1 Capturing Events
CRBasic example Capturing Events (p. 171) demonstrates programming to output
data to a data table at the occurrence of an event.