Campbell CR800 Series - Calgain() Field Descriptions

Section 8. Operation
339
An example use of the Calibrate() instruction programmed to calibrate all input
ranges is given in the following CRBasic code snip:
'Calibrate(Dest,Range)
Calibrate(cal(1),true)
where Dest is an array of 54 variables, and Range ≠ 0 to calibrate all input ranges.
Results of this command are listed in the table Calibrate() Instruction Results
(p.
341).
CalGain() Field Descriptions
Field
±mV Input
Range
Integration
CalGain(1) 5000 250 ms
CalGain(2) 2500 250 ms
CalGain(3) 250 250 ms
CalGain(4) 25 250 ms
CalGain(5) 7.5 250 ms
CalGain(6) 2.5 250 ms
CalGain(7) 5000 60 Hz Rejection
CalGain(8) 2500 60 Hz Rejection
CalGain(9) 250 60 Hz Rejection
CalGain(10) 25 60 Hz Rejection
CalGain(11) 7.5 60 Hz Rejection
CalGain(12) 2.5 60 Hz Rejection
CalGain(13) 5000 50 Hz Rejection
CalGain(14) 2500 50 Hz Rejection
CalGain(15) 250 50 Hz Rejection
CalGain(16) 25 50 Hz Rejection
CalGain(17) 7.5 50 Hz Rejection
CalGain(18) 2.5 50 Hz Rejection