Campbell CR800 Series - PLC Control

To Next Page

To Previous Page

Section 5. Overview

Datalogger support software handles communication between a computer or

device and the CR800. A wide array of software are available, but the following

are the most commonly used:

• Short Cut Program Generator for Windows (SCWin) — Generates

simple CRBasic programs without the need to learn the CRBasic

programming language

• PC200W Datalogger Starter Software for Windows — Supports only

direct serial connection to the CR800 with hardwire or select Campbell

Scientific radios. It supports sending a CRBasic program, data collection,

and setting the CR800 clock; available at no charge at

www.campbellsci.com/downloads

• LoggerLink Mobile Apps — Simple tools that allow an iOS or Android

device to communicate with IP, Wi-Fi, or Bluetooth enabled CR800s;

includes most PC200W functionality.

• PC400 Datalogger Support Software — Includes PC200W functions,

CRBasic Editor, and supports all Campbell Scientific communications

hardware, except satellite, in attended mode

• LoggerNet Datalogger Support Software — Includes all PC400 functions

and supports all Campbell Scientific communication options, except

satellite, attended and automatically; includes many enhancements such

as graphical data displays and a display builder

Note More information about software available from Campbell Scientific

can be found at www.campbellsci.com.

5.11 PLC Control — Overview

Campbell CR800 Series - PLC Control - Overview