Campbell CR800 Series - FIGURE 22: Pulse Sensor Output Signal Types; Pulse Input Channels; Pulses Measured

Section 5. Overview
71
• Low-level ac
C terminals configurable for input for the following:
• State
• Edge counting
• Edge timing
Note A period-averaging sensor has a frequency output, but it is
connected to a SE terminal configured for period-average input and
measured with the PeriodAverage() instruction. See Period Averaging
— Overview
(p. 73).
5.2.3.1 Pulses Measured
The CR800 measures three types of pulse outputs, which are illustrated in the
figure Pulse Sensor Output Signal Types
(p. 71).
FIGURE 22: Pulse Sensor Output Signal Types
5.2.3.2 Pulse Input Channels
Table Pulse Input Terminals and Measurements (p. 71) lists devices, channels and
options for measuring pulse signals.