Campbell CR800 Series - Pulse Measurements: Terminals and Programming; FIGURE 87: Terminals Configurable for Pulse Input

Section 8. Operation
371
FIGURE 87: Terminals Configurable for Pulse Input
Pulse Measurements: Terminals and Programming
Measurement
P
Terminals
C
Terminals
CRBasic
Instruction
Low-level ac, counts

PulseCount()
Low-level ac, Hz

PulseCount()
Low-level ac, running
average

PulseCount()
High frequency, counts
 
PulseCount()
High frequency, Hz
 
PulseCount()
High frequency, running
average
 
PulseCount()
Switch closure, counts
 
PulseCount()
Switch closure, Hz
 
PulseCount()
Switch closure, running
average
 
PulseCount()
Calculated period 
TimerIO()
Calculated frequency

TimerIO()
Time from edge on previous
port

TimerIO()
Time from edge on port 1 
TimerIO()
Count of edges

TimerIO()
Pulse count, period 
TimerIO()
Pulse count, frequency

TimerIO()