Section 8. Operation
Note Although the keyboard display is not required to operate the
CR800, it is a useful diagnostic and debugging tool.
8.11.1 Character Set
The keyboard display character set is accessed using one of the following three
procedures:
• The 16 keys default to ▲, ▼, ◄, ►, Home, PgUp, End, PgDn, Del,
and Ins.
• To enter numbers, first press Num Lock. Num Lock stays set until
pressed again.
• Above all keys, except Num Lock and Shift, are characters printed in
blue. To enter one of these characters, press Shift one to three times to
select the position of the character as shown above the key, then press the
key. For example, to enter Y, press Shift Shift Shift PgDn.
• To insert a space (Spc) or change case (Cap), press Shift one to two
times for the position, then press BkSpc.
• To insert a character not printed on the keyboard, enter Ins , scroll down
to Character, press Enter, then press ▲, ▼, ◄, ► to scroll to the
desired character in the list that is presented, then press Enter.
Special Keyboard/Display Key Functions
Key Special Function
[2] and [8]
Navigate up and down through the menu list one line at
a time
[Enter]
Selects the line or toggles the option of the line the
cursor is on
[Esc] Back up one level in the menu
[Home]
Move cursor to top of the list
[End]
Move cursor to bottom of the list
[Pg Up]
Move cursor up one screen
[Pg Dn]
Move cursor down one screen
[BkSpc]
Delete character to the left
[Shift] Change alpha character selected
[Num Lock] Change to numeric entry
To Next Page
Loading...
