Campbell CR800 Series - Info Tables and Settings: S

Appendix A. Info Tables and Settings
549
RunSignature
Numeric Y
• Station Status field: Run Signature
• Status table field: 9
Signature of the running binary (compiled) program. Value is independent of comments or
non-functional changes. Often changes with operating-system changes. Updates after
compiling and before running the program.
Info Tables and Settings: S
Keyword Data Type
Read Only
• Where to Find
Description
SDCInfo
String Y
• Settings Editor: Advanced | SDC Baudrate
SecsPerRecord()
Numeric Y
• DataTableInfo table
Reports the data output interval (s) for a data table.
Security(1)
Numeric
• Settings Editor: Datalogger | Security Level 1
First level in an array of three security codes. Not shown if security is enabled. 0 disables all
security.
Security(2)
Numeric
• Settings Editor: Datalogger | Security Level 2
Second level in an array of three security codes. Not shown if security is enabled. 0 disables
levels 2 and 3.
Security(3)
Numeric
• Settings Editor: Datalogger | Security Level 3
Third level in an array of three security codes. Not shown if security is enabled. 0 disables
level 3.
SerialNumber
Numeric Y
• Settings Editor: Datalogger | Serial Number
• Status table field: 4
CR800 serial number assigned by the factory. Stored in flash memory. Updated at startup.
Services
Enabled()
Discontinued; replaced by/aliased to HTTPEnabled, PakBusTCPEnabled, PingEnabled,
TelnetEnabled, TLSEnabled
SkipPakBusRing
SkippedRecord()
Numeric Y
• Station Status field: Skipped Records in XXXX
• DataTableInfo table