Section 8. Operation
8.11.7 Configure Display
FIGURE 109: CR1000KD: Configure Display
8.12 CPI Port and CDM Devices — Details
Related Topics:
• CPI Port and CDM Devices — Overview (p. 63)
• CPI Port and CDM Devices — Details (p. 455)
See Appendix C in CDM-VW300 Dynamic Vibrating Wire Analyzers instruction
manual, which is available at www.campbellsci.com/manuals.
CPI has the following power levels:
• Off — not used
• High power — fully active
• Low-power standby — whenever possible
• Low-power bus — sets bus and modules to low power
To Next Page
Loading...
