3. Initial Inspection
• Check the Ships With tab at http://www.campbellsci.com/CR800 for a
list of items shipped with the CR800. Among other things, the
following are provided for immediate use:
o Screwdriver to connect wires to terminals
o Type-T thermocouple for use in the Quickstart
(p. 35) tutorial
o A datalogger program pre-loaded into the CR800 that measures
power-supply voltage and wiring-panel temperature.
o A serial communication cable to connect the CR800 to a PC
o A ResourceDVD that contains product manuals and the following
starter software:
— Short Cut
— PC200W
— DevConfig
• Upon receipt of the CR800, inspect the packaging and contents for
damage. File damage claims with the shipping company.
• Immediately check package contents. Thoroughly check all packaging
material for product that may be concealed. Check model numbers, part
numbers, and product descriptions against the shipping documents.
Model or part numbers are found on each product. On cabled items, the
number is often found at the end of the cable that connects to the
measurement device. The Campbell Scientific number may differ from
the part or model number printed on the sensor by the sensor vendor.
Ensure that the you received the expected cable lengths. Contact
Campbell Scientific immediately about discrepancies.
• Check the operating system version in the CR800 as outlined in the
Operating System (OS) — Installation
(p. 113) and update as needed.
To Next Page
Loading...
