Appendix A. Info Tables and Settings
Info Tables and Settings: I
Keyword Data Type
• Where to Find
Description
IncludeFile
String
• Settings Editor: Advanced | Include File Name
Name of a file to be included at the end of the current CRBasic program, or that can be run
as the default program.
IPAddressCSIO()
String
• Settings Editor: CS I/O IP | IP Address
IPAddressEth
String
• Settings Editor: Ethernet | IP Address
Specifies the IP address for the Ethernet interface. If zero, the address, net mask, and
gateway are configured automatically using DHCP. Made available only if an Ethernet
link is connected. A change will cause the CRBasic program to recompile.
IPGateway
String
• Settings Editor: Ethernet | IP Gateway
Specifies the address of the IP router to which the CR800 will forward all non-local IP
packets for which it has no route. A change will cause the CRBasic program to recompile.
IPGateway
CSIO()
String
• Settings Editor: CS I/O IP | Gateway
• Specifies the gateway for CS I/O. A change will cause the CRBasic program to
recompile.
IPInfo
1
String
• Settings Editor: Ethernet | {information box}
Indicates current parameters for IP connection. IPInfo is a status field but the CR800
processes it as a setting to minimize bandwidth. It requires about 1.5 KB when all IP
interfaces are active. This 1.5 KB is transfered each time it is requested regardless of how
many IP interfaces are actually used. See IPInfo() CRBasic instruction. Updates when
status is queried.
IPMaskCSIO()
String
• Settings Editor: CS I/O IP | Subnet Mask
IPMaskEth
String
• Settings Editor: Ethernet | Subnet Mask
Specifies the subnet mask for the Ethernet interface. This setting is made available when an
Ethernet link is connected. A change will cause the CRBasic program to recompile.
IPTrace
Discontinued; aliased to IPTraceComport
IPTraceCode
UINT2
• Settings Editor: Advanced | IP Trace Code
Controls what type of information is sent on the port specified by IPTraceComport and via
Telnet. Default = 0.
To Next Page
Loading...
