Campbell CR800 Series - Field Calibration - Overview; FIGURE 24: Terminals Configurable for RS-232 Input; FIGURE 25: Use of RS-232 and Digital I;O When Reading; Overview

Section 5. Overview
75
5.2.6.2 RS-232 — Overview
The CR800 has 4 ports available for RS-232 input as shown in figure Terminals
Configurable for RS-232 Input
(p. 75).
As indicated in figure Use of RS-232 and Digital I/O when Reading RS-232
Devices
(p. 75), RS-232 sensors can often be connected to C terminal pairs
configured for serial I/O, to the RS-232 port, or to the CS I/O port with the proper
adapter. Ports can be set up for baud rate, parity, stop-bit, and so forth as
described in CRBasic Editor Help.
FIGURE 24: Terminals Configurable for
RS-232 Input
FIGURE 25: Use of RS-232 and Digital I/O when Reading RS-232
Devices
5.2.7 Field Calibration — Overview
Related Topics:
• Field Calibration — Overview (p. 75)
• Field Calibration — Details
(p. 214)