Section 4. Quickstart
o PDA
o Multidrop, Fiber Optic
o Radio, Satellite
Some comms options can be combined.
4.5 Datalogger Support Software — Quickstart
Related Topics:
• Datalogger Support Software — Quickstart (p. 39)
• Datalogger Support Software — Overview
(p. 86)
• Datalogger Support Software — Details
(p. 396)
• Datalogger Support Software — Lists
(p. 571)
Campbell Scientific datalogger support software is PC or Linux software that
facilitates comms between the computer and the CR800. A wide array of
software are available. This section focuses on the following:
• Short Cut Program Generator for Windows (SCWin)
• PC200W Datalogger Starter Software for Windows
• LoggerLink Mobile Datalogger Starter software for iOS and Android
A CRBasic program must be loaded into the CR800 to enable it to make
measurements, read sensors, and store data. Use Short Cut to write simple
CRBasic programs without the need to learn the CRBasic programming language.
Short Cut is an easy-to-use wizard that steps you through the program building
process.
After the CRBasic program is written, it is loaded onto the CR800. Then, after
sufficient time has elapsed for measurements to be made and data to be stored,
data are retrieved to a computer. These functions are supported by PC200W and
LoggerLink Mobile.
Short Cut and PC200W are available at no charge at
www.campbellsci.com/downloads.
Note More information about software available from Campbell Scientific
can be found at www.campbellsci.com.
4.6 Tutorial: Measuring a Thermocouple
This exercise guides you through the following:
• Attaching a sensor to the CR800
• Creating a program for the CR800 to measure the sensor
To Next Page
Loading...
