Campbell CR800 Series - FIGURE 11: PC200 W View Data Utility; Procedure: (PC200 W Steps 7 to 10)

Section 4. Quickstart
50
4.6.5.5 Procedure: (PC200W Steps 7 to 10)
7. Click the OneMin box so a check mark appears in the box. Under What to
Collect, select New data from datalogger.
8. Click on a table in the list to highlight it, then click Change Table's Output
File... to change the name of the destination file.
9. Click on Collect. A progress bar will appear as data are collected, followed
by a Collection Complete message. Click OK to continue.
10. To view data, click the icon at the top of the PC200W window to open
the View utility.
FIGURE 11: PC200W View Data Utility